Skip to content
Aqualarm

How it fits on your pipe

Scroll to install an actuator valve, connect the Main Unit+ and test the system. The model is simplified and not to scale.

Aqualarm actuator valve
  1. Step 1 of 8

    Start at the water main

    The actuator valve goes on the incoming supply pipe, so it can stop water to the whole property. Find the main stopcock where the supply enters.

  2. Step 2 of 8

    Choose the position

    Fit the valve downstream of the main stopcock and any pressure-reducing valve, on a straight run with room for the actuator and the manual wheel above it.

  3. Step 3 of 8

    Shut off, drain and cut in

    Close the stopcock and drain the line. Remove a section of pipe to suit the valve body, using fittings that match your pipe and local plumbing code.

    Installation should be carried out by a qualified plumber.

  4. Step 4 of 8

    Fit the valve

    Seat the valve with the flow arrow pointing downstream and tighten the threaded connections. Brass bodies are for drinking water; choose bronze for flushing or sea water.

    Compare valve sizes and materials

  5. Step 5 of 8

    Connect the Main Unit+

    Mount the Main Unit+ on a wall nearby and plug in the valve cable. Need more distance? Add the 5 m valve extension. Power it from the 12 V supply.

  6. Step 6 of 8

    Place the sensors

    Put a NEW End Unit wherever water would collect first: under sinks, behind the washing machine, beside the water heater. Each Main Unit+ takes up to 10.

    See sensor units

  7. Step 7 of 8

    Open the water and test

    Reopen the stopcock and put a little water on a sensor. The Main Unit+ sounds the alarm and the valve closes the supply. With a gateway, the app gets the alert too.

  8. Step 8 of 8

    It keeps itself ready

    Every 5 days the control unit turns the valve to keep it moving freely, without interrupting your water. Below 4 °C it closes the valve to protect the pipes.

Before you start

Have these ready, or send us the details and we will specify the kit for you.

Valve size
Match the valve to the supply pipe: DN15 (½″) to DN50 (2″).
Valve body
Brass for drinking water. Bronze for flushing or sea water.
Fittings
Connectors to suit your pipe material, to local plumbing code.
Power
A mains socket within reach of the Main Unit+ for its 12 V supply.
Cable run
Up to the supplied valve cable, or add the 5 m valve extension.
For app alerts
A 2.4 GHz Wi-Fi network where the gateway will sit.